Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Press this button to turn the ionizer feature ON/OFF.
When the ionizer is turned on, it will assist in the purification of the room air.
Water drainage
When the drainage tank is full, the tank full indicator light will turn on, the
operation will stop automatically and the buzzer will beep 15 times to alert the
user that the water needs to be emptied from the drainage tank.
Automatic Defrost
When the unit is running under the condition of 5 ºC ≤ room temperature ≤ 12 ºC, it
will be stop to defrost for every 30 minutes.
When the unit is running under the condition of 12 ºC < room temperature ≤ 20 ºC, it
will be stop to defrost for every 45 minutes.
Emptying the Drainage Tank
1.
Lightly press on the sides of the tank with both hands and pull the tank out
gently. (Fig 1)
2.
Discard the collected water. (Fig 2)
3.
When replacing the drainage tank, press the tank firmly into place with both
hands. If the tank is not in a safe position, the "TANK FULL" sensor will be
activated, and the dehumidifier will not operate. (Fig 3)
1
2
3
Note
1.
Do not remove the float from the water tank. The water full sensor will no
longer be able to detect the water level correctly without the float and water
may leak from the water tank. (Fig 4)
2.
If the drainage tank is dirty, wash it with cold or lukewarm water. Do not use
detergent, scouring pads, chemically treated dust cloths, gasoline, benzene,
thinner, or other solvents, as these can scratch and damage the tank and cause
water leakage.
4
Continuous Water Drainage
The unit features a continuous drainage port.
Using a plastic pipe (with an inner diameter of
10mm); the water in the drainage tank can be
continuously drained out from the continuous
port on the unit. (Fig 5)
CLEANING AND STORAGE
Cleaning
When used regularly, the filter may become clogged with
dust and particles. Therefore, the filter should be cleaned
at least every two weeks. Follow these steps:
1.
Switch the device off and remove the plug from the
socket before cleaning.
2.
Clean the housing with soft, dry cloth. If the device is
extremely dirty, use a mild cleaning agent. Wipe the
dehumidifier with a slightly damp cloth. Never spray
50 | 51
GB
5
B
A
Publicité
Table des Matières
