Allen + Roth 39508 Mode D'emploi page 5

ASSEMBLY INSTRUCTIONS
3. Mounting surface should be clean, dry, flat
and 1/4 in. larger than the fixture (A) on all
sides. Any gaps between the mounting
surface and fixture (A) exceeding 3/16 in.
should be corrected as required with silicone
caulking compound (not included).
Caulk completely around where back of
fixture (A) will meet the wall surface to
prevent water from seeping into outlet box.
4. Pass fixture (A) over the long machine screws
(DD) protruding from the mounting bracket
(B) and secure in place with threaded knobs
(CC).
Note: Be sure to use a clean cloth to wipe away
the excess caulk created from adhearing the
fixture to the wall.
Hardware Used
Threaded
CC
Knob
5. Insert 60-watt max. medium-base
incandescent bulb or CFL/halogen/LED
equivalent (none included).
3
4
x 2
5
5
A
DD
CC
B
A
allenandroth.com
E