Publicité
Les langues disponibles
Les langues disponibles
2. Connect the transmitter to your audio
source using the supplied AK 2 con-
necting cable (white = left-hand chan-
nel, red = right-hand channel).
3. Plug the cable on the supplied AC
adapter into the DC 12 V jack on the
transmitter rear panel.
4. Plug the AC adapter into a convenient
power outlet.
6 Charging Battery Packs
Before you can use the headphones, you
will need to charge the battery pack
inside the headphones. We recommend
charging the supplied replacement bat-
tery pack at the same time.
Refer to fig. 3.
1. Place the headphones (1) on the
transmitter (2).
2. Insert the supplied replacement bat-
tery pack (3) into one of the charging
slots in the transmitter side panels.
The charging process will start auto-
matically. The appropriate indicator
LED(s) (4a or 4b for the replacement
battery packs, 4c for the battery pack
inside the headphones) will be lit red.
The two battery packs will be fully
charged in approx. four hours. The
indicator LEDs (4) will remain lit.
You can leave the headphones on the
transmitter and the battery packs
inside the charging slots without risk-
ing to overcharge the batteries.
Note: The charging slots on the transmit-
ter allow you to charge two battery
packs along with the battery pack
inside the headphones (see fig. 3/1).
BALANCE K 216 AFC
7 Powering Up
Before switching power to your system
on, please note:
• Using headphones at high volume
levels, particularly for extended peri-
ods of time, may damage your hear-
ing.
• Operating switches on your hi-fi sys-
tem or connecting the transmitter to
your audio source may cause clicks,
which at high volume settings may
affect your hearing. Therefore, be sure
to set the volume control on the
headphones to minimum (see fig. 5)
before switching between different
sources (tuner, turntable, CD player,
etc.) or connecting the transmitter.
• Interference caused by other users of
the same frequency band is beyond
AKG's control.
1. Remove the headphones from the
transmitter.
2. Switch power to your audio source
(and/or hi-fi system) on.
3. The transmitter will switch on auto-
matically. The green transmitter status
LED will be lit.
If a battery pack is being charged
inside the transmitter, the appropriate
charging LED will remain lit red.
Note: If no signal arrives at the transmit-
ter input for five minutes, the transmit-
ter will switch off automatically and
the green transmitter status LED will
go out.
4. Put the headphones on referring to
fig. 4.
9
Publicité
