Safety Instructions Relating Specifically To The Equipment - Meister MET14/16-2 Traduction Du Manuel D'utilisation Original

b Do not use the power tool if the
switch does not turn it on and
of. Any power tool that cannot
be controlled with the switch is
dangerous and must be repaired.
c Disconnect the plug from the
power source before making any
adjustments, changing accessories,
or storing power tools. Such
preventive safety measures reduce
the risk of starting the power tool
accidentally.
d Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are
dangerous in the hands of untrained
users.
e Maintain power tools with care.
Check for misalignment or binding
of moving parts, breakage of parts
and any other condition that may
afect the power tool's operation.
If damaged, have the power tool
repaired before use. Many accidents
are caused by poorly maintained
power tools.
f Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
g Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of
the power tool for operations different
from those intended could result in a
hazardous situation.
34
MW-5459560-Bedien-2006.indd 34 MW-5459560-Bedien-2006.indd 34
5 Service
a Have your power tool serviced
by a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.
b If the mains connection cable of this
device is damaged, it must be replaced
with a special connection cable that
can be obtained from the manufacturer
or their customer service.
6 – Safety instructions
relating specifically to
the equipment
• Always assume that the tool
contains staples. Careless handling
of the stapler can lead to staples
being fired off unintentionally and
causes injuries.
• N ever turn the tool on yourself
or on other people. Unexpected
triggering with discharge the staples
and cause injuries.
• Only activate the tool when it is
pressed up firmly against the item
you are working on. If the tool is not
in contact with the work piece, the
staples may miss their target.
• Unplug the tool from the power
supply or battery if a staple is
trapped in the tool. When removing
the trapped staple, the stapler may
be triggered accidentally if it is still
connected to the power.
• Be careful when removing a
trapped staple. The mechanism may
be under tension and the stapled may
suddenly shoot out when you attempt
to release it.
25.06.20 12:27 25.06.20 12:27