Installation And Setting; Operation - Meister MET14/16-2 Traduction Du Manuel D'utilisation Original

• N ever use the stapler to secure
electrical cables. It is not designed
for securing electrical cables and is
capable of damaging the insulation of
the cables and thus causing electrical
shock or a fire.
• Pull out plug before loading staples.
• Switch the appliance off before
inserting plug into socket.
• Ensure that the power cable is well
away from the appliance.
• Do not touch touch-sensitive switch.
• Never point appliance at people or
animals! Staples or nails fired at close
range may cause serious injury.
• Use only appropriate staples.
• Check the magazine lock before
using.
• During breaks in work push the lock
switch (1) to „O/Off".
• Wear ear protectors and protective
gloves.
• Do not use the appliance to fasten
down electric cables or leads.
Safety symbols
The symbols on the housing have the
following meanings:
Do not dispose of with
domestic waste!
Important! Observe
operating instructions!
MW-5459560-Bedien-2006.indd 35 MW-5459560-Bedien-2006.indd 35
„Tested Safety" voluntary
quality mark
CE Mark (conformity to
European safety standards)
Housing is double insulated
BJ Year of construction
SN: Serial number
SN: XXXXX T he first two underlined
numbers give the month of
manufacture.
7 – Installation and setting
Inserting staples/nails
Unplug from the power source!
Press the magazine lock (6) and pull
the slider out (Figure 2). The slider must
be pulled out to be able to operate the
clamping force switch (7). Now push
the clamping force switch (7) into the
desired position (Fig. 6) following the
marking on the housing. Insert the
stable/nail strips into the magazine
(Figures 3 and 4). Push the slider back
into place and lock (Figure 5).
8 – Operation
It is normal for the unit to warm up
during operation, this is not a fault.
The device is triple secured against
accidental triggering:
Switching on
Set the On/Off switch (4) to the I setting.
35
25.06.20 12:27 25.06.20 12:27