Cleaning And Maintenance; Technical Specifications - HQ Power VDL100GM Mode D'emploi

• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Don't connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
5. Use
Switch the device on and off by means of the power plug. Do not operate the device continuously.
The fixture is designed to operate as a stand-alone unit, there is no external controller needed. This unit is ready to
plug in, out of the box. If there is no lamp output, check the lamp or the fuse. If these are good please contact your
dealer.
Mode switches:
The unit comes with two mode switches on the rear of the unit. Switch 1 controls the reflector dish; switch 2 controls
the gobo wheel. When the switches are in the up position (position 1) the wheels will rotate continuously regardless
of the sound. When the switches are in the middle position (position 0) the wheels will remain static (no rotation).
When the switches are down (position 2) the wheels will be sound-activated. Each wheel will operate separately.

6. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. The housing, the lenses, the mounting supports and the installation location (e.g. ceiling, suspension, trussing)
should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting supports, do not
change the location of the connections, ...
3. Mechanically moving parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts, apart from the lamp and the fuse (see "Installation").
8. Contact your dealer for spare parts if necessary.

7. Technical Specifications

Power Supply
Power Consumption
Fuse
Dimensions
Total Weight
Lamp
Max. Ambient Temperature
Max. Housing Temperature
The information in this manual is subject to change without prior notice.
VDL100GM
max. 230VAC / 5 0Hz
max. 100W
5A, 250VAC (5 x 20mm) (order code FF5N)
248 x 235 x 171mm
4.54kg
1 x 12V / 100W FCR GY6.35 (order code LAMP100/12E (economy)
(incl.), LAMP100/12 (Philips), LAMPOS46625 (Osram))
45°C
130°C
3 VELLEMAN