S&P MAX-TEMP Série Manuel D'instructions page 6

- If a ventilator is installed in a duct, the duct must be exclusively for the ventilation system.
Starting up.
Before starting up the machine, make sure that:
- The apparatus is well secured and the electrical connections have been carried out correctly.
- The safety devices have been adequately connected.
- No loose material or fitting remains can be sucked up by the ventilator. If the ventilator has been mounted in a
duct, make sure it is clear of loose material.
- The earth fittings are adequately connected.
- The electrical safety devices are correctly connected, adequately adjusted and ready for use.
- The wire and electrical connections inputs are correctly sealed and water-tight.
When starting up the machine, make sure that:
- The propeller turns in the correct direction.
- There are no abnormal vibrations.
- If any of the electrical safety devices blow, the apparatus must be quickly disconnected from the mains supply.
The whole installation should be carefully checked before trying to start up the machine again.
Maintenance.
- Before manipulating the ventilator, make sure it is disconnected from the mains supply even if it has previously
been switched off. Prevent the possibility of anyone else connecting it while it is being manipulated.
- The apparatus must be regularly inspected. These inspections should be carried out bearing in mind the
machine's working conditions, in order to avoid dirt or dust accumulating on the propeller, turbine, motor or
grids. This could be dangerous and perceptibly shorten the working life of the ventilator unit.
- While cleaning, great care should be taken not to unstable the propeller or turbine.
- All maintenance and repair work should be carried out in strict compliance with each country's current safety
regulations.
Recycling.
- EEC Standards, together with the responsibility we should assume with future generations in mind, oblige us to
recycle all the materials we can. Therefore, please deposit all left-over material and packaging in their
corresponding recycling containers and hand in the replaced machines to the nearest handler of this type of
waste product.
If you have any queries about S&P products, please contact our after-sales service in Spain, or your local S&P
dealer in any other country. If in doubt, please visit our Web-Page at www.solerpalau.com