Bradley S19-330ST Mode D'emploi page 2

Bradley Drench Shower Tester
Model No. S19-330ST
Installation Instructions
Step 1:
• Remove plastic cap from end of adjustable handle (Figure 1).
Step 2:
• Slide the end of the bag hoop over the end of handle until it snaps into place (as shown
in Figure 2).
NOTE: To release hoop/bag from handle, press on the release button and pull hoop/bag off the
end of the handle (Figure 1).
Step 3:
• Replace plastic cap removed in Step 1 in end of handle.
Step 4:
• To adjust handle height (adjusts to approximately 6 feet), pull up on handle until the
tab pops out of the hole on handle (Figure 1).
2
Bradley Corporation
Installation Instructions
215-826 Rev. D; EN 98-685