Outdoor Unit Installation; Installation Place - Olimpia splendid SHERPA S2 E 12 Manuel D'installation Et D'utilisation

6 OUTDOOR UNIT INSTALLATION

6.1 Installation place

Please keep away from the following place, or malfunction of the
machine may be caused:
1) There is combustible gas leakage.
2) There is much oil (including engine oil) ingredient.
3) There is salty air surrounding(near the coast)
4) There is caustic gas (the sulfide, for example) existing in the air
(near a hotspring)
5) A place the heat air expelled out from the outdoor unit can reach
your neighbor's window.
7) A place where the drain water does not make any problem.
6) A place that the noise interferes your neighbors every day life.
3) A place that is not exposed to a strong wind.
7) A place that is too weak to bear the weight of the unit .
4) A place that does not block a passage.
8) Uneven place.
9) Insufficient ventilation place.
Near a private power station or high Frequency equipment.
Install indoor unit, outdoor unit, power cord and connecting
wire at least 1m away from TV set or radio to prevent noise or
picture interference.
CAUTION
● When an outdoor unit is installed in a place that is always
exposed to a strong wind like a coast or on a high storey of a
building, secure a normal fan operation by using a duct or a
wind shield.
● When the outdoor unit is installed in an elevated position,be
sure to 4secure its feet.
● Keep indoor unit, outdoor unit, power supply wiring and
transmission wiring at least 1 meter away from televisions and
radios. This is to prevent image interference and noise in those
electrical appliances. (Noise may be generated depending on
the conditions under which the electric wave is generated,
even if 1 meter is kept.)
● The insulation of the metal parts of the building and the heater
pump should comply with the regulation of National Electric
Standard.
6.2 Installation space (unit：mm)
12~16kW
1) Single unit installation
Air inlet
>300
Air inlet
4
A
(Wall or obstacle)
>600
Air outlet
Fig.6-2
Fig.6-4
Maintain
channel
Fig.6-5