ENGLISH
Connecting a control dock for iPod
• Connect a control dock for iPod to the unit to enjoy video and music stored
on an iPod.
• For a control dock for iPod, use ASD-11R, ASD-3N, ASD-3W, ASD-51N and
ASD-51W made by DENON (sold separately).
• For instructions on the control dock for iPod settings, refer to the control
dock for iPod's operating instructions.
Control dock for iPod
R
L
z
R
L
zUse the AV/Control Cable supplied with the DENON
control dock for iPod.
in Set as Necessary
Set this to change the digital input connector to which the input source
is assigned.
"Input Assign" (vpage 31)
16
Connecting an antenna
• Connect the FM antenna or AM loop antenna supplied with the unit to enjoy listening to radio broadcasts.
• After connecting the antenna and receiving a broadcast signal (vpage 20 "Listening to FM/AM broadcasts"), fi x the antenna with tape
in a position where the noise level becomes minimal.
Direction of broadcasting station
FM outdoor
antenna
75 Ω Coaxial
cable
FM indoor
antenna
(supplied)
AM outdoor
Ground
antenna
n AM loop antenna assembly
Put the stand section
1
through the bottom of the
loop antenna from the
rear and bend it forward.
Loop
antenna
Insert the projecting part
2
into the square hole in
the stand.
q
w
e
n Using the AM loop antenna
Suspending on a wall
Suspend directly on a wall without
assembling.
Stand
Standing alone
Square
hole
Use the procedure shown left to
assemble.
Projecting
part
NOTE
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect the
AM loop antenna.
• Make sure the AM loop antenna lead terminals do not touch
metal parts of the panel.
• If the signal has noise interference, connect the ground
terminal (GND) to reduce noise.
• If you are unable to receive a good broadcast signal, we
recommend installing an outdoor antenna. For details, inquire
at the retail store where you purchased the unit.
AM loop antenna
(supplied)
Black
White
Nail, tack, etc.