Technical Specifications - Güde GLS 2800 VD Mode D'emploi Original

Introduction
Please read thoroughly this operation manual and
attached safety instructions to enjoy your machine. We
further recommend to retain the operation manual for
future references. We reserve right to make technical
changes for the purpose of improvement in the course of
continuous product development.
Translation of original operating instructions.
Supply includes
Take the appliance out of the transport container and
check whether there are the following parts:

Leaf vacuum

Leaf collection bag

Shoulder strap
If any parts are missing or are damaged, please contact
your dealer.
Use as designated
Leaf vacuum including the suction and blowing feature
may only be used for leaves and garden waste such as
grass and small branches.
The appliance cannot be used for works other than those
for which it has been designed and that are specified in the
Operating Instructions.
Any other use will be considered a use in conflict with the
designation. The manufacturer will not be liable for any
consequential damage and injuries. Please be sure to
know that our appliances have not been designed for
industrial use.
Appliance description (pic. A)
1. Front suction/blowing tube
2. Suction/blowing tube adjustment lever
3. Back suction/blowing tube
4. Fixture
5. Shoulder strap eye
6. Variable speed adjustment
7. ON/OFF button
8. Handle
9. Plug/feeder cable
10. Cable strain relief equipment
11. Leaf collection bag
12. Suction/blowing function adjustment lever
13.
14. Guide wheels
15. Shoulder strap

Technical specifications

Connection:
Engine output:
Protection class:
Protection type:
Air speed:
Suction/blowing volume:
Composting ratio:
Collection bag capacity:
Assembly dimensions:
Weight:
230 V ~ 50 Hz
2,800 W
II
IP 23
8,000 15,000 per min-1
3
7.5 – 14 m per hour
10:1
45 l
815x185x240 mm
5.5 kg
Operator requirements
The operators must thoroughly read operation manual
before use.
Qualification
Except for thorough training by an expert for use of the
device, no special qualification is required.
Minimum age
The device may be operated by persons over 16 years of
age. An exception is use by younger person if the use
takes place under supervision of an adult trainer in the
course of education.
Training
Use of the device requires corresponding guidance by an
expert or operation manual only. No special training is
required.
Before putting the appliance into operation
Assembly
Collection bag assembly (pic. B-D)
Put the collection bag to the engine unit fixture as shown in
pic. C. The bag will snap in by pressing the lock (pic. B/1).
To disassemble the bag, proceed in reverse order.
Fitting the shoulder strap (pic. E)
Put the shoulder strap to the equipment (pic. A/5). Now
you can adjust the shoulder strap length as required.
Please make sure the assembled parts are fitted
properly.
Before putting the appliance into operation, check
it for the following:

Whether cables are not damaged

Whether all the screwing is tightened properly
Safety instructions
The Operating Instructions must be read thoroughly before
using the appliance for the first time. If there are any
doubts regarding the appliance connection and operation,
contact the manufacturer (service department).
TO ENSURE HIGH SAFETY LEVEL, FOLLOW
CAREFULLY THESE INSTRUCTIONS:
Caution! To be connected only to network with a
safety switch against stray current (FI)!
The leaf vacuum must never be used without the
suction/blowing tube!

The user is liable for any accidents and risks caused
by third parties to themselves or their property.

Keep children and pets in a safe distance from the
running leaf vacuum (at least 6 metres).

Safe non-slip shoes, gloves, protective glasses,
headphones and long trousers always need to be
worn when working with the appliance.

If the leaf vacuum is used in dusty conditions, wear a
respirator.

Never aim a running leaf vacuum at face.

Make sure your hands, legs, hair or parts of clothing
do not get near openings and moving parts.

Do not wear wide pieces of clothing and jewels that
could be drawn in the air supply opening.

Before putting the leaf vacuum into operation, make
always sure it is assembled properly.

Never use the leaf vacuum when raining or in moist
conditions.
9