Metabo SPA 1200 Instructions D'utilisation page 15

2. Pull out the mains plug and store it in
such a way that the person using the
device can see that the plug is re-
moved.
3. wait until the machine has come to
a complete stop.
– Repair and maintenance work oth-
er than described in this section
should only be carried out by quali-
fied specialists.
– Replace defective parts, especially
of safety devices, with genuine re-
placement parts only. Parts not test-
ed and approved by the manufac-
turer can cause unforeseen
damage.
– Check to see that all safety devices
are operational again after each
service.
6.1 Maintenance
Before switching ON
Visual check to see if power supply ca-
ble and power cable plug are damaged;
have faulty parts replaced by a qualified
electrician.
The machine requires no maintenance.
However, before switching ON perform
the following checks.

Check all screw connections!
Retighten loose connections.

Is the switch housing, motor or fan
housing damaged? Have these
parts immediately replaced by a
qualified electrician.

Is the upper dust bag or suction
hose damaged? Replace the dam-
aged part(s).
6.2 Cleaning
In event of reduced suction pow-

er:
– Loosen the suction clamp and
pull off the suction hose from the
union beneath the electric motor.
– Clean the grille.
– Reattach the suction hose and
hose clamp and tighten the hose
clamp.

Wipe work stand and fan housing
with a moist cloth.
 Motor and ON/OFF switch may only
be cleaned with a dry cloth.

The upper dust bag should only be
beaten (make sure dust collection
bag is installed on the underside of
the machine).

Change the chip collection bag
when it is about 4/5 full.
6.3 Storage

For storing the dust extractor, place
the suction hose over the motor and
insert the end in the opening in the
base plate.
A
Danger!
Store the machine in such way that

it can not be started by unauthor-
ised persons.

Make sure that nobody can get hurt
by the stored machine.
A
Caution!

Do not store machine unprotected
outdoors or in damp environment.
6.4 Repairs
A
Danger!
Repairs to electric tools may only be
carried out by a qualified electrician!
If the mains connection cable of this de-
vice is damaged, it must be replaced by
the manufacturer or the Customer Ser-
vice department of the manufacturer or
a similarly qualified person to prevent
endangering personnel and property.
Contact your local Metabo representa-
tive if you have Metabo power tools re-
quiring repairs. See www.metabo.com
for addresses.
You can download a list of spare parts
from www.metabo.com.
ENGLISH
7. Available Accessories
For special tasks the following accesso-
ries are available from specialist retail-
ers:
A Automatic power relay
order number: 0913014626
ALV 1, single-phase 230 VAC,
for time-delayed switch-on or
switch-off of the dust extractor after
the woodworking machine has been
switched on or off.
B Automatic power relay
order number: 0913014634
ALV 10, three-phase 400 VAC, sin-
gle-phase 230 VAC
C Filter cartridge
order number: 0920016529
filters out ultrafine dust particles,
effective filter surface 52 m
D Chip collection bag
order number: 0913017617
8. Disposal
Power tools should not be
disposed of with household
waste. According to Europe-
an directive 2002/96/EC on
waste electrical and elec-
tronic equipment used pow-
er tools must be collected separately
and taken to an appropriate recycling
facility.
Contact your local council for the dis-
posal options for your old tool.
The tool packaging is 100% recyclable.
2
15