Publicité
Les langues disponibles
Les langues disponibles
devices (see Spare Parts
List for stock numbers).
Do not change any parts.
A
Hazard generated by
tool defects!
Keep machine and acces-
sories in good repair. Ob-
serve the maintenance in-
structions.
Before each use check the
machine for possible dam-
age: before operating the
machine carefully check all
safety devices, protective
guards and slightly dam-
aged parts for proper func-
tion. Check to see that all
moving parts work properly
and do not jam. All parts
must be correctly installed
and meet all conditions
necessary for the proper
operation of the machine.
The machine must not be
operated when the electric
motor, ON/OFF switch or
fan housing are damaged
Never use the machine if
the power supply cable is
damaged. Risk of electric
shock. Have a damaged
power supply cable re-
placed by a qualified elec-
trician immediately.
Damaged protection devic-
es or parts must be re-
paired or replaced by a
qualified specialist. Have
damaged switches re-
placed by a service centre.
Do not operate machine if
the switch can not be
turned ON or OFF.
3.3 Symbols on the
Machine
Danger!
Disregard of the fol-
lowing warnings can
lead to severe per-
sonal injury or mate-
rial damage.
Read instructions.
Wear safety glass-
es and hearing pro-
tection.
Wear dust mask.
Do not operate tool
in damp or wet envi-
ronment.
4.
Assembly
1. Place fan housing (7), with the mo-
tor facing down, on a workbench or
similar stable support and set it lev-
el with a block of wood or similar.
9
8
9
8
7
2. Loosen the 3 hexagon nuts and
washers (9) shown on both sides of
the ventilator housing. Mount the 2
plates as shown on the bolts. Guide
the two side panels (8) over the
bolts with the adhesive label poin-
ting outwards. Fit all washers and
re-tighten all nuts on the ventilator
housing.
10
3. Install the cross plate (10) between
the side panels using carriage bolts
and hex flange nuts.
.
11
12
4. Screw one castor (11) to each cor-
ner of the bottom panel. Secure
each castor with a hex nut (12).
7
5. Screw the earthing chain (13) into
the bottom panel. Secure the earth-
ing chain with a hex flange nut.
6. Place the thus prepared bottom
panel on the side panels and secure
ENGLISH
13
13
Publicité
Chapitres
