Drain Valve - Staba ER1 Mode D'emploi

Usage:
The power cord can be found at the bottom of the appliance. Unwind before the use.
Put the power cord in the guidance to have a stable stand.
The appliance has 2 safety controls:
∙ Infinitely variable capillary thermostat
This controls from 30°C to 99°C. The thermostat is set to the required temperature,
the lamp illuminates and the appliance heats the liquid. If you would like to cook
continuously, set the thermostat to max. Keep the lid closed at all times.
∙ Overtemperature protection
This is activated if the appliance is operated without liquid or the liquid has boiled
dry. In this case the fusible safety plug will activate. The appliance must then be
sent to our customer service department.
120 minute timer
The appliance is set using the timer. When the timer elapses the appliance turns itself
off. The appliance can be set to continuous operation by setting the control knob to
ON.
Attention! In this case there
must be sufficient liquid in the
pot, and the appliance must be moni-
tored.

Drain valve

(only with art. no.: 051200 and 051100)
This is suitable for liquids with low viscosity (e.g.
mulled wine). Viscous liquids will block the valve.
Regular cleaning is required. To do this, unscrew
the upper section above the drain and rinse it
with hot water. Tighten upper section finger-tight
when assembling. Ensure that the valve is sealed.
Lid
Always close the device with the lid. If you put the lid upside down on the device, you
can use it as a heated storage tray for mussled wine.
(only with art. no.: 051200 and 051100)
9