Table des Matières
Publicité
LITE
EN
Remove the remote control:
To remove the remote control, keep the
the display flashes C , when it stops flashing, press the
seconds have passed or it will be necessary to repeat the complete operation.
Unit functions:
- F0 - Manual function.
- F1
- Digital thermometer function.
- F2 - Time programming function.
- F4 - Unit automatic operation function.
- F6 - ºF Selection function.
Turning the unit on
Press the On/off
up in Function F4 (Automatic Function). To change function, keep On/off
down on the control panel, passing through the different functions on the display, and
release when the required function is shown. When running for the first time, the unit will
start up with the default parameters.
Function F0 - Manual operation
Selecting F0 in the display shows the selected temperature and allows the user to
choose the comfort temperature which will be displayed, from 15ºC to 27ºC or 59ºF to
71ºF, and to change the unit's blower speed (5 speeds indicated with the characters u1
to u5 ).
Comfort temperature is controlled by pressing the keys
on the remote control.
The centrifugal blower speeds will be controlled by keeping the
control panel pressed down or from
u1 , u2 , u3 , u4 , u5 . The display shows the degrees selected when the unit is running.
Function F1 - Digital thermometer function
The interior cabin temperature is displayed when selecting this function.
key on the control panel or remote control. The unit always starts
on the remote control, with the display showing
10
-
key on the control panel pressed down until
+
+
key on the panel before 30
pressed
-
on the control panel or
-
keys on the
+
®
Publicité
Table des Matières
