AEG MRC 4119 P N Mode D'emploi page 60

English
60
Inserting the Battery (Backup)
(Battery is not included with the device)
In case of a power cut or if the device is unplugged, with backup battery inserted, the set-
tings will be kept.
1. Open the battery compartment at the bottom. Remove for this the screw of the bat-
tery compartment lid with a Phillips screwdriver.
2. Insert one battery of the type CR2032, 3 V. Mind the correct polarity (indicated on the
bottom of the battery case)!
3. Close the battery case. Secure the battery compartment lid again with the screw.
4. If the device is not used for an extended period of time, remove the Battery from the
device to avoid any leaking of battery acid.
CAUTION:
Batteries are not to be disposed of together with domestic wastes. Dispose of the used
batteries at the relevant collection bin or at your dealer' s .
WARNING:
Do not expose the batteries to high temperatures or direct sunlight. Never throw batter-
ies into the fire. There is a danger of explosion!
Power supply
• Insert the grid plug into a properly installed socket.
• Make sure the grid voltage corresponds to the figures on the rating plate.
• If no backup battery has been inserted, the clock settings and channel memory will be
lost in the event of power interruptions.
Switching the Unit On/Off
Press the button (8) to switch the unit on or off.
Volume
Adjust the volume with
Display Brightness
In standby mode, use the SNOOZE/SLEEP/DIMMER button (9) to adjust the display
brightness.
NOTE:
The display brightness settings will also apply to the switched on device.
(12) and (11) buttons.