Operation - Cameo LED FLASH MATRIX 250 Manuel D'utilisation

OPERATION

After the spotlight has been correctly connected to the mains and switched on, it is ready for use and the mode that was previously selected
is activated.
SELECTING THE DMX START ADDRESS
Press the MODE button repeatedly until the currently set DMX address appears on the display (A001 - A512). Using the UP and DOWN
buttons, the DMX start address can now be set as desired. Confirm the input with ENTER. The synchronous control of multiple spotlights
(same model) through a DMX control unit (e.g. DMX console) can be achieved by assigning the spotlights to an identical DMX start address
and DMX mode and connecting them using DMX cables.
UP/DOWN
SETTING THE DMX MODE
Press the MODE button repeatedly until one of the 7 available DMX modes is displayed (CH01, CH02, CH03, CH05, CH10, CH25, CH30).
The DMX mode can be adjusted as desired by using the UP and DOWN buttons. Confirm the input with ENTER. You will find tables with the
channels of the different DMX modes in this manual under DMX CONTROL.
UP/DOWN
AUTOMATIC CONTROL
Select one of the 11 different Auto programs (SH01 - SH11) and adjust their speed (SP01 - SP10). Press the MODE button repeatedly until
of the auto programs appears on the display, select the desired program using the UP and DOWN buttons and confirm by pressing ENTER.
Press the MODE button once to access the menu item for setting the program speed. One of the 10 speed levels will be shown on the
display and you can use the UP and DOWN buttons to select the desired speed as required (SP01 - SP10). Confirm the input with ENTER.
UP/DOWN
-
MUSIC CONTROL
Select the Music control mode to control the spot via the built-in microphone (bass pulses). Press the MODE button repeatedly until "SnoF"
or "Snon" appears on the display. Now use the UP and DOWN buttons to select the menu item "SnoF" for "Music control disabled" or
"Snon" for "Music control enabled" and press ENTER to confirm. Press the MODE button once to access the menu item for adjusting the mi-
crophone sensitivity. The currently set value will be shown on the display and you can use the UP and DOWN buttons to select the sensitivity
with which the spotlight reacts to sound, as required (SE01 = minimum sensitivity, SE99 = maximum sensitivity). Confirm with ENTER.
UP/DOWN
/
6
- -> ENTER
- -> ENTER
-> ENTER -> MODE
-> ENTER -> MODE
UP/DOWN
-
UP/DOWN
-
-> ENTER
-> ENTER