Lighting Instructions; To Turn Off Gas To Appliance - Empire OL48TP10-1 Instructions D'installation Et Mode D'emploi

FOR YOUR SAFETY READ BEFORE LIGHTING
If you do not follow these instructions exactly, a fire or explosion many result causing property damage,
personal injury, or loss of life.
a. BeFORe liGHTinG, smell around the appliance area for
gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHaT TO DO iF YOU SMell GaS
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions. if you can not reach your gas
supplier, call the fire department.
This fireplace is for outdoor use only.
Read all instructions before lighting.
Any accessory weather cover(s) must be removed before use.
Remove any debris – including leaves and insects – from the
burner area and the bed of crushed glass.
1. Before turning on the main gas supply, press the ignitor
button. Verify that the ignitor is sparking above the burner
between the electrode and the thermocouple.
2 Turn on the main gas supply to fireplace.
3 With the gas control knob in the "OFF" position press and
hold the ignitor button. Lightly press and rotate the gas
control knob to the HI/IGNITION position. Press down and
hold down the gas control knob.
If the burner fails to light after 5 seconds, turn gas control
knob to OFF. Wait 5 minutes to dissipate gas before at-
tempting to relight.
4 Once the burner ignites, release the ignitor button but con-
tinue to press down on the gas control knob for 30 seconds.
(This allows the thermocouple (flame sensor) to heat up,
confirming that the firepit is burning.)
If flame goes out, turn knob to OFF, wait 5 minutes, repeat
lighting sequence starting with step 3.
1. Open control door.
2. Push in gas control knob slightly and turn clockwise
to "OFF". Do not force.
3. Turn off all electric power to appliance if service is to be
performed.
4. Close control door.
37795-3-0119

liGHTinG inSTRUcTiOnS

LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
WaRninG
B. Use only your hand to push in or turn the gas control
knob. never use tools. if the knob will not push in or
turn by hand, don't try to repair it, call a qualified service
technician. Force or attempted repair may result in a fire
or explosion.
c. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
Gas control Knob shown in
"OFF" position
Page 21