Empire OL48TP10-1 Instructions D'installation Et Mode D'emploi page 20

crushed Glass installation
Ensure the burner cover screens are still properly installed,
fully covering the LED openings. Place decorative crushed
glass evenly over the burner and screens (enough media to
cover approximately 7 sq. ft. on OL48TP, or 8 sq. ft. on OL60TP
models). (See page 6 for media requirements). Ensure coverage
is even and not thicker in places.
NOTICE: Excessive amounts of crushed
glass placed over the burner, electrode,
or thermopile may cause various issues
including delayed lighting or sooting.
COVER ENTIRE BURNER AND SCREENED
AREAS WITH CRUSHED GLASS
IF DESIRED GLASS DROPLETS
MAY BE ADDED IN AREA SHOWN - DO NOT USE DROPLETS
Page 20
FiRepiT inSTallaTiOn (cOnT'D)
FINISHING
SPREAD CRUSHED GLASS AWAY
FROM THERMOCOUPLE AND
ELECTRODE
ON BURNER
Some pieces of broken glass may be larger than others. It is
fine to use these pieces, but not over the burner or flame area.
See Figure 29. Decorative glass droplets may be added as an
enhancement, but can not be used near or over the burner. See
Figure 30. Neither glass nor droplets may be placed over the
electrode. (See page 6 for media accessories and requirements).
DO NOT COVER
Figure 29
Figure 30
37795-3-0119