Disposal; Installation Environment; Technical Data - Jet-tech EV18 Mode D'emploi

1C – DISPOSAL
This appliance is marked according to the
European directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE). By
ensuring this product is
correctly, you will help
negative consequences for the environment
and human health, which could otherwise be
caused by inappropriate waste handling of
this product. The symbol:
on the product, or on the documents
accompanying the product, indicates that this
appliance may not be treated as household
waste. Instead it should be handed over to the
applicable collection point for the recycling of
electrical and electronic equipment. Disposal
must be carried out in accordance with local
environmental regulations for waste disposal.
1D – TECHNICAL DATA
WATER CONNECTION
Temperature °C
Pressure kPA
Bar
PSI
Flow Lt/min
Hardness
°dH
ppm
Mineral residues mg/l
Conductivity µS/cm
disposed of
prevent potential
50
°F 122
200-400
2-4
29 - 58
20 - 30
°f 7 - 14
4 - 7,5
°e 5 - 9,5
70 - 140
300 / 400
300 / 400
ELECTRICAL CONNECTION
Voltage V
Frequency Hz
Wash Cycle °C
Rinse Cycle °C

INSTALLATION ENVIRONMENT

Operating °C
Temperature °F
Storage °C
Temperature °F
1D1– NOISE LEVEL
Environment noise level cannot exceed the
values as per Standards
installation. The noise of the machine,
measured at the manufacturer site, was less
than 70dB, approximately 58dB.
When using the machine the following data
must be complied with
transportation, utilization and maintenance of
the machine. This documentation can be
updated and the manufacturer can reserve the
rights to modify present values.
± 6 %
± 1 %
55
85
5 - 35
41 - 95
10 - 70
50 - 158
of place of
the storage,
6