Bodypack Transmitter Connection; System Connection - Skytec 179.165 Mode D'emploi

BODYPACK TRANSMITTER CONNECTION

1.
Lavaliere Microphone Connection: Connect the connecter of supplied. Lavaliere microphone to the
connecting jack of transmitter (Shown as below) Set the transmitter work state in wireless lavaliere system.
2.
Headset Microphone Connection: Connect the connecter of supplied Headset microphone to the connecting
jack of transmitter(Shown as below) Set the transmitter work state in wireless head set system.

SYSTEM CONNECTION

1. Receiver Power Connection: Connect the DC connector of supplied AC/DC adapter into the DC power input
of receiver. Plug the AC input connecter into an 230~240VAC/50Hz outlet. (Shown as below)
2. Antenna: Keep the position of antenna at a 45 angle from vertical, .(Shown as below)
3. Audio Connection: Connect the corresponding output of receiver by supplied 6.3mm phone jack audio cable
or your XLR cable to the input of power amplifier, mixer.
BODYPACK TRANSMITTER AUDIO GAIN ADJUSTMENT
The audio gain control on transmitter has been factory-at the mid-range position for best performance in most
applications. This may be necessary for soft singers or talkers, or guitar or basses with low outputs.

To Increase Gain: Rotate the transmitter gain control clockwise with the screwdriver to increase audio
gain.

To Reduce Gain: Rotate the transmitter gain control counter clockwise with the screwdriver to reduce
audio gain.

To return audio gain to the factory setting, rotate the transmitter audio gain control to the mid position