Teka XT2 8910 Mode D'emploi page 14

EN - Instruction on mounting and use
Closely follow the instructions set out in this manual. All
responsibility, for any eventual inconveniences, damages or fires
caused by not complying with the instructions in this manual, is
declined. This appliance is intended to be used in household and
similar application such as: - staff kitchen areas in shop, offices
and other working environments; - farm houses; - by clients in
hotels, motels and other residential type environments; - bed and
breakfast type environments.
The hood can look different to that illustrated in the drawings
in this booklet. The instructions for use, maintenance and
installation, however, remain the same.
• It is important to conserve this booklet for consultation at any
moment. In the case of sale, cession or move, make sure it is
together with the product.
• Read the instructions carefully: there is important information
about installation, use and safety.
• Do not carry out electrical or mechanical variations on the
product or on the discharge conduits.
• Before proceeding with the installation of the appliance verify
that there are no damaged all components. Otherwise
contact your dealer and do not proceed with the installation.
Note: The parts marked with the symbol "(*)" are optional
accessories supplied only with some models or otherwise not
supplied, but available for purchase.
Caution
• Before any cleaning or maintenance
operation, disconnect hood from the mains
by removing the plug or disconnecting the
mains electrical supply.
• Always wear work gloves for all
installation and maintenance operations.
• This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning use of
the appliance in a safe way and
understand the hazards involved.
• Children shall not be allowed to tamper
with the controls or play with the appliance.
• Cleaning and user maintenance shall not
be made by children without supervision.
• The premises where the appliance is
installed must be sufficiently ventilated,
when the kitchen hood is used together
with other gas combustion devices or other
fuels.
• The hood must be regularly cleaned on
both the inside and outside (AT LEAST
ONCE A MONTH).
• This must be completed in accordance
with the maintenance instructions provided.
Failure to follow the instructions provided
regarding the cleaning of the hood and
filters will lead to the risk of fires.
• Do not flambé under the range hood.
• Do not remove filters during cooking.
• For lamp replacement use only lamp type
indicated in the Maintenance/Replacing
lamps section of this manual.
The use of exposed flames is detrimental
to the filters and may cause a fire risk, and
must therefore be avoided in all
circumstances.
Any frying must be done with care in order
to make sure that the oil does not overheat
and ignite.
CAUTION: Accessible parts of the hood
may become hot when used with cooking
appliances.
• Do not connect the appliance to the mains
until the installation is fully complete.
• With regards to the technical and safety measures to be adopted
for fume discharging it is important to closely follow the regulations
provided by the local authorities.
• The air must not be discharged into a flue that is used for
exhausting fumes from appliance burning gas or other fuels.
• Do not use or leave the hood without the lamp correctly mounted
due to the possible risk of electric shocks.
• Never use the hood without effectively mounted grids.
• The hood must NEVER be used as a support surface unless
specifically indicated.
• Use only the fixing screws supplied with the product for
installation or, if not supplied, purchase the correct screws type.
• Use the correct length for the screws which are identified in the
Installation Guide.
• In case of doubt, consult an authorized service assistance center
or similar qualified person.
WARNING!
• Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards.
• Do not use with a programmer, timer, separate remote
control system or any other device that switches on
automatically.
14