Nikon AT-10 Manuel D'utilisation page 22

4. Using the AT-10
4. Using the
Transparency Unit
Step 1
Turn on the scanner. The Power, Ready and
Option indicators should light.
Step 2
Raise the transparency unit and place a
transparency on the scanner's document setting
glass. Make sure that the transparency is placed
within the area bordered by the green rulers.
Step 3
Lower the transparency unit.
The scanner is ready to scan transparencies after
launching your scanning software. Be sure to
select the transparency scan type from your
software to scan transparencies.
Note: Before you use the transparency unit
and the scanner, you need to install the
application software and scanner software/
driver.
To protect your transparencies from distortion,
use a Slide Holder. The holder's frame provides
ample area for grasping the transparency
without risking damage from fingerprints and
surface scratches.
10 Nikon
Transparency Unit User's Manual