Top Panel; Turning The System On - Roland CUBE Monitor CM-110 Mode D'emploi

Turning the System On

Top Panel

[CH 1], [CH 2], [CH 3] knobs
These adjust the volume of the sound
being input at the CH 1 jacks, CH 2 jacks,
and CH 3 jack.
EQUALIZER knobs
Adjusts the volume of
[LOW] knob
the lower range.
Adjusts the volume of
[HIGH] knob
the upper range.
Turning the System On
* To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off all devices before making any
connections.
* Once the connections have been completed, turn on your various devices in the order specified. By turning on devices in the wrong order, you risk
causing malfunction and/or damage to speakers and other devices.
1.
Set the [MASTER] knob
to 0.
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after turning on is required before the unit will operate normally.
* Before turning on/off the unit, always be sure to turn the volume down. Even with the volume turned down, you might hear some sound when
turning on/off the unit. However, this is normal and does not indicate a malfunction.
* If you need to turn off the power completely, unplug the power cord from the power outlet. Refer to "Power Supply" (p. 3).
6
[MASTER] knob
This adjusts the overall volume of the
output from the main unit (subwoofer) and
satellite speakers.
[WOOFER] knob
This adjusts the volume of the output from
the main unit (subwoofer).
2.
Turn on the connected
equipment.
NOTE
This system will be turned off automatically when
approximately 4 hours have passed without any input signal
being detected.
If you don't want the system to be turned off automatically,
set the [AUTO OFF] switch to the "OFF" position.
[AUTO OFF] switch
The system will be turned off automatically
when 4 hours have passed without any input
signal being detected.
ON
* To resume operation, turn the unit off, then
on again; or set the [AUTO OFF] switch to the
"OFF" position.
OFF The system will not turned off automatically.
This will light in red when the system
is on.
[ON] switch
This turns the system on.
[PHASE] switch
This changes the phase of the sound that is output from the
main unit (subwoofer) (p. 4).
3.
Turn the system on.