Pentair Water Pool and Spa MagicStream Laminar Guide D'installation page 11

11
LED Light Engine Features
The LED Light Engine controls the operation of the following features, and its built-in memory
capability ensures that each time you turn the light engine on, it resumes operation with the same
features in operation as when you last turned it off:
Lighting
Color freeze mode
Color changing mode
following three programs:
Solenoid Thumper
The solenoid thumper feature creates a "wrinkle" in the laminar stream, thus creating a brilliant
spot of light in the laminar arc.
Reset
When you select the reset feature, the LED light engine reverts to the Random color changing
mode with the solenoid thumper ON.
Operating the LED Light Engine Features
You control the operation of the LED light engine features by cycling the power OFF and ON
rapidly (1SEC) in the combinations described below:
IMPORTANT: Start from the ON position.
Lighting
through
Solenoid Thumper
Reset
-You choose one color of light. The color does not change.
-the color of the light changes automatically, according to one the
- Colors will change at 10 sec intervals. In this mode, multiple
Sync
Laminars will change colors together.
- Colors will change at about 10 sec intervals but in a completely random
Random
sequence. In this mode, multiple Laminars will NOT change colors together.
- Colors will change randomly and slowly at first, then speed up, until the sequence
Party
ends with quick flashes and strobes. The sequence then repeats, beginning with the slow
changes. In this mode, multiple Laminars will NOT change colors together
- cycle the power OFF/ON 2 times. Each successive OFF/ON combination will cycle
and
Sync, Random Party
- cycle the power OFF/ON 3 times to turn the solenoid thumper ON and OFF.
- cycle the power OFF/ON 4 times to reset the LED light engine.
.