Pentair Water Pool and Spa MagicStream Laminar Guide D'installation page 10

10
Light Enhancer Setup (darkness required)
You may elect to vary the intensity of the light when using the LED light source to light the laminar
stream. You can adjust the light intensity by means of the light enhancer. The light enhancer uses a
very small stream of water to add very small bubbles to the stream. The screw that controls the light
enhancer is located on the Laminar orifice plate (Figure 6).
There is no optimal setting for the light enhancer, and the intensity of the light emitting from the
laminar stream is purely a matter of taste. We encourage you to experiment with the light enhancer
to achieve the effect you desire.
NOTE: Laminars are sensitive to wind, earth movement and equipment vibration. Secure the Laminar
and Deck Housing to minimize vibration. Periodic stream distortion, caused by pump vibrations and motor
electrical fluctuations, is normal and not indicative of a nozzle defect.
NOTE: A Laminar may occasionally "burp" as a result of trapped air accumulating in the nozzle body.
This phenomenon is normal and will occur until all air is purged from the piping system. Trapped air can
also cause slight distortion in water action. It is imperative that all air is removed to ensure proper water
feature operation.
Figure 6
Control screw
Light
enhancer