Installation Instructions - H.Koenig CAVS12 Manuel D'utilisation

INSTALLATION INSTRUCTIONS

Before putting your appliance into service
l Remove all inner and outer packaging components.
l This appliance is designed to be free standing.
l Before connecting your device to a power supply, allow it to stand
upright for about 2 hours. This reduces the risk of malfunction of the
refrigeration system due to handling during transport.
l Clean the inner surfaces of the unit with a soft cloth and warm water.
l Leave 10cm of free space between the back and sides of the unit to
allow for ventilation of the cooling system. Failure to do so will result in
poor cooling performance, dust build up on the components and
dramatically shorten the life of the product. It may also void the
warranty.
Below are the guidelines for creating proper ventilation
Ventilation basics: While the unit is cooling(removing the heat)from its
interior, the removed heat is being dissipated through the condenser
coil at the rear of appliance.
This heat must be removed with proper air circulation and exhausted
to the outside of the cabinet enclosure. If this is not done, excessive
heat will build up inside the cabinet enclosure and prevent the unit
from maintaining proper cooling, increase power consumption and
overheat the electrical components.
l Place your unit on a floor strong enough to support the weight of the
fully filled unit.
l Make sure the unit is level by adjusting the front feet underneath the
unit. Make sure that the appliance rests on its feet in a stable manner.
l Install the appliance away from direct sunlight and heat sources
(radiator, hot plate, etc.). Direct sunlight can damage the unit's coating
and heat can increase its power consumption.