Installing And Connecting Up - Siemens SIMATIC NET CP 5603 Manuel

Operating Instructions (compact) CP 5603

Installing and connecting up

Caution
When handling the module, make sure that you do not touch the connectors or the
electronic components.
Please remember to keep to the measures to prevent electrostatic discharge (ESD-
Electrostatic Discharge)
Setting the PCI-104 module address
Each PCI-104 module must be assigned a module address according to its position. The
module address is set using the address switch (see below). Chapter 2.3 shows the position
of the address switch.
The module address is set at the address switch as described below:
Module address
Notice
Module address 4 is not permitted in the SIMATIC Microbox.
Notice
Make sure that all module addresses are set so that they match the slot before you
commission the device.
32
Switch 1
1 on
2 on
3 off
4 off
Switch 2 Comment
on Factory setting
off
on
off
CP 5603 Operation Instructions (compact)
4
A5E02146341A-01