Siemens SIMATIC NET CP 5603 Manuel page 24

Safety notices
This manual contains notices which you should observe to ensure your own personal safety, as well as to protect
the product and connected equipment. The notices relating to your personal safety are highlighted in the manual
by a warning triangle, notices relating to general damage to equipment and property do not have a warning
triangle. The warning notices are shown in descending order according to the degree of danger as follows.
Danger
indicates that death or severe personal injury will result if proper precautions are not taken.
Warning
indicates that death or severe personal injury can result if proper precautions are not taken.
Caution
with a warning triangle indicates that minor personal injury can result if proper precautions are not taken.
Caution
without a warning triangle indicates that damage to property can result if proper precautions are not taken.
Notice
indicates that an undesirable result or status can occur if the relevant notice is ignored.
If more than one degree of danger is present, the notice representing the highest degree of danger will be used. A
notice warning of injury to persons with a warning triangle may also include a warning relating to property
damage.
Qualified personnel
The relevant device/system may only be set up and operated in conjunction with this documentation. Only
qualified personnel should be allowed to install and work on this equipment/system. Qualified persons are defined
as persons who are authorized to commission, to ground, and to tag circuits, equipment, and systems in
accordance with established safety practices and standards.
Correct usage
Note the following:
Warning
This software may only be used for the applications described in the catalog or the technical description, and
only in connection with devices or software products from other manufacturers which have been approved or
recommended by Siemens. This product can only function correctly and safely if it is transported, stored, set up,
and installed correctly, and operated and maintained as recommended.
Trademarks
All names shown with the ® character are registered trademarks of Siemens AG. Third parties using for their own
purposes any other names in this document which refer to trademarks might infringe upon the rights of the
trademark owners.
Disclaimer
We have checked the contents of this manual for agreement with the hardware and software described. Since
deviations cannot be precluded entirely, we cannot guarantee full agreement. However, the data in this manual
are reviewed regularly and any necessary corrections included in subsequent editions.
Siemens AG
Industry Sector
Postfach 48 48
90327 Nürnberg
Germany
Document order number: A5E02146341A-01
Ⓟ 09/2008
Copyright © Siemens AG 2008.
Subject to change