Setting Up The Device; Getting Started - VOLTCRAFT MSO-5062B Mode D'emploi

UNPACKING
Check all the parts for completeness and damage after unpacking.
Damaged parts must not be used for safety reasons. In case of any damage,
contact our customer service.

SETTING UP THE DEVICE

Set up the device, using the handle or the device's pedestal, so it can be operated and read
comfortably.
Avoid direct sunlight over a longer period since this could damage the screen.
In order to comply with the technical tolerance data, the device has to be oper-
ating for about 20 minutes within the given operating temperature range.

GETTING STARTED

Insert the mains cable provided into the mains socket at the back of the device, and connect
the safety plug to an earthed mains socket.
Switch on the device with the power switch (POWER I/0). The oscilloscope is activated when
the switch is held in the pressed position.
The device shows a start screen and is ready for operation after a short initialisation phase.
Connect the corresponding measuring lines/probes to the BNC connector of the input channel
CH1 or/and CH2.
The measuring voltage should only be applied to the internal conductor.
The external conductor (reference earth) is connected to the earth potential
(protective earth conductor).
Touch the object to be measured with the probes.
For automatic signal setting push the "AUTO SET" button.
This function sets the time base, the vertical defl ection and the trigger level automatically to
optimise the signal visualisation on the oscilloscope.
Remove the probe from the object after fi nishing the measurement, and turn off the device.
CLEANING
Always observe the following safety instructions before cleaning the device:
If you open covers or remove parts – unless you can do this by hand – live
parts may be exposed.
Prior to cleaning or repairing the device, all lines must be detached and the
device must be turned off.
Do not use abrasive, chemical or aggressive cleaning agents such as benzene, alcohol etc.
These might attack the surface of the device. Furthermore, the fumes are hazardous to your
health and are explosive. Moreover, you should not use sharp-edged tools, screwdrivers or
metal brushes or such like for cleaning.
For cleaning the device or the display and the measuring cables, use a clean, slightly damp,
lint-free, antistatic cloth.
Should you have any questions concerning the handling of the device, please
do no hesitate to contact our Technical Support:
Voltcraft®, 92242 Hirschau, Lindenweg 15,
Phone +49 180 / 586 582 7
DISPOSAL
Electrical and electronic products do not belong to the household waste. Dispose
of an unserviceable product in accordance with the relevant statutory regulations.
You thereby fulfi l your statutory obligations and contribute to the protection of the environ-
ment!
Legal notice
These operating instructions are a publication by Voltcraft®, Lindenweg 15, D-92242 Hirschau/Germany, Phone +49 180/586 582 7
(www.voltcraft.de).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfi lming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© Copyright 2013 by Voltcraft®