FORGE ADOUR Origin Serie Notice D'utilisation page 21

Precautions for use
To ensure safe use of your FORGE ADOUR
plancha, it is essential to comply with the
different rules for installation and use below:
• Remenber to remove the protective
adhesive film from the stainless steel
parts.
• Between use, be sure to close the gas
bottle valve
• For use indoors, be sure to keep distance
of 17 cm between your appliance and
the vertical partitions surrounding your
appliance (recess).
• Do not store or use flammable products or
vapours near the plancha.
• If there is a smell of gas, close the gas
bottle valve or the wall valve in the case of
natural gas supply.
• If the appliance is placed on a support
(table, ect...), it must imperatively be
fitted with its 4 legs
• Your FORGE ADOUR plancha is not
connected to a combustion product
discharge system. It must be installed
and connected in accordance with the
installation rules in force. Particular
attention shall be paid the the applicable
provisions regarding ventilation. A 15
m3/h fresh air flow is to be provided for
the combustion air supply.
• Warning : some accessible parts may be
very hot. Keep young children away .
• Do not move the appliance while in
operation.
• Do not use an adjustable pressure relief
valve.
• Allow the plancha to cool before cleaning
the chassis and handling the grease tray.
• Make ure that the hose is not in contact
with the hot parts of the applaince.
• If your appliance is protected by a soft
cover, be sure to remove it completely
before using the plancha.
• If your plancha is equiped with a lid, make
sure that this lid is the "OPEN" position
while heating and use.
• For use without a FORGE ADOUR wheeled
unit or support : the gas bottle (13kg)
which supplies the plancha must be placed
80 cm away from the appliance.
• If the plancha is to be used on a wheeled
unit support, it is essential to use a bottle
weighing 6 kg max.
• Warning : tightness is to be checked
outdoors, away from any source of
ignition.
• Make sure that the control switches are
in the closes position. After opening the
bottle and resetting the pressure relief
valve check that there are no bubbles on
all fitting, on the pressure relief valve and
on the appliance, unsing soapy water.
The presence of bubbles indicates a leak.
Close the gas bottle and tighten all the
fittings.
Repeat the tightness test. If the leak comes
from the appliance, do not use your
plancha and contact the manufacturer or
the retailer. Test the tightness every time
the bottle is replaced.
Danger : never test the tightness of your
appliance with flame. Never use a leaking
appliance.
• It is recommended to wear protective
gloves when handling particulary hot
components.
• The parts prtected by the manufacturer
must not be handled by the user. None of
the gas line components are to be modified
by the user. The gas containers that can
be used on this type of appliance rage from
6 to 13 kg (Dimension, height : 560 mm
and depth : 310 mm max, pressure relief
valave included).
• Comply with the use-by dates of your
hose, and replace it if need be. Test the
tightness every time the hose is replaced.
• Check the position of the connecting hose
to ensure that it is not in contact with the
hot part of the appliance.
EN
21