MSI A88XI AC Mode D'emploi page 42

▶ Advanced DRAM Configuration
Press <Enter> to enter the sub-menu. This sub-menu will be activated after setting [Link]
or [Unlink] in "DRAM Timing Mode". User can set the memory timing for each memory
channel. The system may become unstable or unbootable after changing memory tim-
ing. If it occurs, please clear the CMOS data and restore the default settings. (Refer to
the Clear CMOS jumper/ button section to clear the CMOS data, and enter the BIOS to
load the default settings.
▶ DRAM Voltage [Auto]
Sets DRAM voltage. If set to "Auto", BIOS will set the voltage automatically or you can
set it manually.
▶ Spread Spectrum
This function reduces the EMI (Electromagnetic Interference) generated by modulating
clock generator pulses.
[Enabled] Enables the spread spectrum function to reduce the EMI (Electromag-
netic Interference) problem.
[Disabled] Enhances the overclocking ability of CPU Base clock.
Important
• If you do not have any EMI problem, leave the setting at [Disabled] for optimal
system stability and performance. But if you are plagued by EMI, select the value of
Spread Spectrum for EMI reduction.
• The greater the Spread Spectrum value is, the greater the EMI is reduced, and
the system will become less stable. For the most suitable Spread Spectrum value,
please consult your local EMI regulation.
• Remember to disable Spread Spectrum if you are overclocking because even a
slight jitter can introduce a temporary boost in clock speed which may just cause
your overclocked processor to lock up.
▶ CPU Memory Changed Detect [Enabled]
Enables or disables the system to issue a warning message during boot when the CPU
or memory has been replaced.
[Enabled] The system will issue a warning message during boot and than needs to
load the default settings for new devices.
[Disabled] Disables this function and keeps the current BIOS settings.
▶ OC Retry Count [1]
Resets counts for overclocking retrying. When overclocking has failed, setting this
item as [1, 2, 3] will allow system to reboot 1, 2, 3 times with the same overclocked
configuration. If overclocking has failed every time, the system will restore the defaults.
▶ CPU Specifications
Press <Enter> to enter the sub-menu. This sub-menu displays the information of in-
stalled CPU. You can also access this information menu at any time by pressing [F4].
Read only.
▶ CPU Technology Support
Press <Enter> to enter the sub-menu. The sub-menu shows what the key features
does the installed CPU support. Read only.
En-30