Cabling; Default Settings - Atlantis NetPower 303 WN Guide De Démarrage Rapide

5. Cabling

Plug NetPower 303 WN into the wall outlet/socket.
With the power source on, once the device is connected, the Power, LAN and WLAN
port LEDs will light up indicating a normal status.
If the LAN Port's Link indicator does not light up then check the RJ-45 cable if it is
firmly feed to the RJ45 port, while the LAN is link up to the Switch/Hub, the LAN
port's LED will light up.
The control LEDs of the device are clearly visible and the status of the network link
can be seen instantly.

6. Default SETTINGS

The NetPower 303 WN can be configured with your Web browser. The web
browser is included as a standard application in following operation systems, UNIX,
Linux, Mac OS, Windows XP/2000/Vista/7, etc. The product provides a very easy
and user-friendly interface for configuration.
Before Configuration
This section describes the configuration required by LAN-attached PCs that
communicate with the NetPower 303 WN, either to configure the device, or for
network access. These PCs must have an Ethernet interface installed properly, be
38