Atlantis NetPower 303 WN Guide De Démarrage Rapide page 37

LED
WLAN Lit green when the wireless function is enabled.
Blinking when data is transmitted or received via WLAN.
Blinking quickly when WPS is proceeded.
POWER Lit green when the device is power on.
Lit off when power is off.
PLC Lit green when the power line sync is established.
Blinking quickly when data is transmitted or received via power line.
Blinking after Sync button is pushed (see Sync Button descripted below).
ETH Lit green when connected to an Ethernet device.
Blinking when data is transmitted or received via Ethernet port.
BUTTON
WPS Push this button to trigger Wi-Fi Protected Setup function.
SYNC Used to establish a LAN network with other power line devices.
Push this button for 1~3 second(s) and release it to set device enter the
power line Sync state.
Press the Sync Button of device for more than 10 seconds to make sure
that it is detached completely from any possible network group.
RESET Press this button 3 seconds to reset device to factory default settings.
Due to the incompatibility of HomePlug AV 200 with HomePlug
1.0 devices, the presence of the HomePlug 1.0 devices within
the powerline network will thus reduce the performance of
your powerline network.
For a device which already belongs to a network group is to
join with a different network group, that device has to be
ungrouped from its current attached group first. Press the Sync
Button of device for more than 10 seconds to make sure that
it is detached completely from any possible network group.
MEANING
MEANING
37