Pleasant Hearth PH35PS-B Série Manuel Du Propriétaire page 2

Follow all instructions and warnings for safe startup of stove. Failure to follow instructions could result in
During startup and normal operation your appliance's front door must be closed.
Odors and vapors are released during initial startup after purchase. Burning your appliance on HI for 30 minutes will
allow the paint to cure. Open windows or doors for air circulation until burn-off is complete.
1.
Turn Dial Control to OFF and ensure appliance is
completely shut down, Figure 2.1.
2.
Ensure appliance is completely cooled and clean
pot (see Cleaning Fire pot in the General
Maintenance section of Owner's Manual under
Maintaining and Servicing the Appliance)
3.
Open front door and ensure all
installed properly, Figure 2.2 (also see Clean
the General Maintenance section of Owner's
Manual under Maintaining and Servicing the
Appliance).
*Once close door.*
4.
Inspect hopper and ensure there is pellet fuel in
the hopper. If there is fuel in the hopper, close lid
and proceed to step 5, Figure 2.3.
NOTE: If the hopper is completely empty, the
appliance will need to have pellet fuel added to the
hopper and may need to be primed (see Priming
The Feed Tube in the General Operating Infor-
mation section of Owner's Manual).
5.
Turn dial control to desired setting.
-Green light will start blinking rapidly to indicate
startup sequence.
NOTE: If the appliance fails to ignite, the LED light will
blink red 4 times continuously indicating a missed
ignition alarm; repeat lighting steps 1 through 5.
NOTE: It may take up to 20 minutes for a missed
ignition alarm.
2
Lighting Instruction Guide
CAUTION
injury or damage.
are
Lighting Instructions • December 06, 2016
7077-801D • September 17, 2019
Figure 2.1
2 2
1 1
3 3
Figure 2.2
Push Bottom of Latch
Inward to Release
Figure 2.3
(877) 477- 4768