Important Remarks - HQ Power MICW43 Mode D'emploi

5. Operation
Preparing the Transmitter for Use
Open the battery compartment and insert 2x AA batteries (order code
LR6C, not incl.) respecting the polarity. Insert the plug of the optional
microphone (order code MICW44 or MICW45, not incl.) into the input
jack.
Channel Selection
Switch on the transmitter by sliding the power switch to ON. Press SET and
select the display menu [disp]. Wait 2 to 3 seconds and select the channel
menu (channl) using ▲ or ▼. Press SET again to enter the menu. You will
see next display.
Wait 2 to 3 seconds. Next, you will be given the choice to lock [loc on] or to
unlock [locoff] the transmitter's settings. Choose [locoff] using ▲ or ▼.
Press SET again to enter the menu. Choose your channel using ▲ or ▼ and
press SET again to confirm.
Frequency Selection
Press SET and select the display menu [disp]. Wait 2 to 3 seconds and
select the frequency menu [fyegu] using ▲ or ▼. Press SET again to enter
the menu. You will see next display.
Wait 2 to 3 seconds. Next, you will be given the choice to lock [loc on] or to
unlock [locoff] the transmitter's settings. Choose [locoff] using ▲ or ▼.
Press SET again to enter the menu. Choose your frequency using ▲ or ▼
and press SET again to confirm.
NOTE: By selecting [loc on], you will lock the transmitter's settings.

6. Important Remarks

 Keep the transmitter 1m above the ground and 1 m away from walls for
the best results.
 Turn off your device before changing the batteries.
 Never open the transmitter's housing.
 Make sure to match the frequency or the channel on your receiver and
your microphone / transmitter.
 Use only fresh alkaline batteries as partially drained batteries may
cause weak signal reception.
V. 03 – 21/01/2019
MICW43
4 ©Velleman nv