GRE VCB10 Manuel D'instructions page 9

Problem
Cleaner does not
capture the debris
Garbage flowing out
from the Transparent
Suction Head part
Garbage flow out from
the rear filter bag
Handle/pole connector
cannot be secured in
assembly
Cleaner cannot be
recharged
Possible Cause
Battery is running out
Impeller is jammed
Impeller is broken
When the filter bag
is full
The soft rubber of
the rear impeller is
broken
Filter sock is
damaged
Side pin broken
Battery is dead
The charger is out of
order
Remedy
Charge the battery again. Normally
cleaner can operate 45~60 minutes
after fully charged.
Power off the cleaner and visually check
the gap in middle of the cleaner to see if
the impeller is jammed. you can use your
hand to rotate the impeller two circles to
make the impeller rotation looser.
WARNING! Make sure cleaner is
power off when servicing the cleaner.
Contact your dealer for impeller
replacement.
Detach the filter basket and filter bag,
and clean them.
The soft rubber of rear impeller is like a
door in case the garbage in the filter bag
will flow backwards into impeller and the
cover of transparent suction head part.
Replace a new filter sock.
Using the new V-Shape clip
Make sure it is well closed.
Contact dealer for battery replacement.
WARNING! When you replace the
battery, please contact the local
dealers to purchase the original
lithium battery in case that the electric
cleaner is destroyed.
Contact dealer for proper transformer.
WARNING! Using wrong charger will
result in damaging the cleaner
/battery and void the warranty.