Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Use the original the charger provided only.
Make sure cleaner and the charger are clean and dry before set up.
NOTE: Charge the cleaner 3 hours prior to the first use.
Normally cleaner can be operated for 45 to 60 minutes after fully charged.
Set Up for Operation
�
�
--
_____
Handle assembly
lnsert the handle as shown behind big department, according to needs, looking
for what kind of convenient way to clean the wall and bottom of the POOUSPA,
you find easier to hold the cleaner when cleaning the pool / spa wall and
bottom. lnsert the handle into the cleaner as shown until the side pin on the
handle is secured in the Handle Locking Hole on the cleaner.
To ralease the handle, press down the side pin and pull out the handle.
Telescopic pole assembly
lnsert the end(with one side pin)of the Pole Connector into the cleaner as
shown until its single side pin is secured in the Hand Locking Hole of the
cleaner. Slide and align the side holes of the telescopic with the side pins of the
Pole Connector.
To release the telescopic pole, press down two side simultaneously and pull
out the pole.
,...._
S
���
____
4
..-
The arrow of transparent suction head part
and transparent body should be aligned, and
then you can put down the transparent
garbage can to the bottom of transparent
body. Then rotate 90 degrees rightly ( from
open to el ose).
Publicité
Table des Matières
