Metrohm KF 768 Mode D'emploi page 33

3.2 Remote control commands3.2 Remote control commands
3.2.2.41 Setup.RamInit
Initialises the device as in the diagnostic test, see page 42: All parameters are set to the
default value and error messages are cleared.
3.2.2.42 Setup.InstrNo
Setup.InstrNo.Value
Device identification outputted in the report. The serial number and manufacturing number
are entered here in the factory as an unequivocal identification.
3.2.2.43 Setup.Save
All entries made via RS232 must be saved with &Setup.Save $G before the instrument is
switched off to avoid losses.
30
$G
$G
up to 8 ASCII
$G
768 KF Oven