heat produced by the compressor then evaporates the condensates collected in the tray.
The winter system
The winter kit is a frost protection system which enables the cellar to operate in an environment where
the temperature is between 0 and 32°C. A sensor located inside the appliance triggers a low power
electrical element when the inner temperature of the wine cellar becomes inferior by 3°C than the set
temperature. This is a low power element to avoid sudden rises in the temperature of the wine and so
avoid thermal shocks that are damaging to the preservation of the wine. The kit is intended to raise the
cellar's internal temperature even before there is a thermal exchange with the bottles.
The kit is designed to heat the internal temperature of the cellar even before a heat exchange has
occurred with the bottles. The winter system keeps the temperature inside the wine cellar the same as
the programmed temperature. When the system is activated and the internal temperature reaches the
set temperature, the system stops.
Shelves
To prevent damage to the door seal, ensure that the door is fully open before pulling out the
shelves to add or remove bottles.
For easier access to the contents of the shelves, slide the shelf out approximately one third of the
way. The shelves are, however, fitted with a stop to prevent the bottles falling out.
To remove or reposition the shelves, incline the shelf as indicated in the diagram, then push or pull
as required.
Foot sliders
Two foot sliders are provided with your appliance, allowing you to move it easily when your feet are
adjusted to maximum height. The foot sliders have to be installed in parallel under the feet in
accordance with the location for the front and for the back.
Front
Back
40