HQ Power VDPDP134 Notice D'emploi page 5

5. Operating Instructions
Manual Control : Manual control is possible through the channel faders if neither an analogue or DMX controller
Preheating : Enables you to adjust the min. output level (between 0-50%), which enhances the life of the
Analogue Input : Connect the analogue controller according to the diagram below. The device supplies the
DMX Input : The dimmer pack can receive DMX512 signals. Adjust the DIP switches to confirm the start
Setting the DMX Start Address :
VDPDP134
are used. Slide them up or down to adjust the output (dimming level) for each channel.
lamps.
controller with DC power.
address of the device. When the 10
the sliders, then all channels will react simultaneously and they will all be placed at the same
level.
switch is placed in the ON-position and you move one of
th
5 VELLEMAN