Klarstein VIRTUOSA FLEX 90 Mode D'emploi page 48

EN
48
Make sure the induction cooker hob is well ventilated and that air inlet and outlet are
not blocked. In order to avoid accidental touch with the overheating bottom of the hob,
or getting unexpectable electric shock during working, it is necessary to put a wooden
insert, fixed by screws, at a minimum distance of 50 mm from the bottom of the hob.
Follow the requirements below:
Note: Be aware that the glue that join the plastic or wooden material to the furniture,
has to resist to temperature not below 150°C, to avoid the unstuck of the paneling.
The rear wall, adjacent and surrounding surfaces must therefore be able to withstand
an temperature of 90°C.
Before Installing the Hob
Make sure that:
• The work surface is square and level, and no structural members interfere with
space requirements.
• The work surface is made of a heat-resistant and insulated material.
• If the hob is installed above an oven, the oven has a built-in cooling fan.
• The installation will comply with all clearance requirements and applicable
standards and regulations.
• A suitable isolating switch providing full disconnection from the mains power supply
is incorporated in the permanent wiring, mounted and positioned to comply with the
local wiring rules and regulations.
• The isolating switch must be of an approved type and provide a 3 mm air gap
contact separation in all poles (or in all active [phase] conductors if the local wiring
rules allow for this variation of the requirements).