Troubleshooting - JVC KW-AVX800 Manuel D'instructions

Troubleshooting

What appears to be trouble is not always serious. Check the following points before calling a service center.
• For operations with the external components, refer also to the instructions supplied with the adapters used for the
connections (as well as the instructions supplied with the external components).
Symptoms
• No sound comes out of the center speaker.
• No sound comes out of the rear speakers, and
subwoofer.
• No sound comes out of the subwoofer while
playing in stereo.
• The monitor is not clear and legible.
• You cannot select "SD" and "USB" as the
source.
• The remote controller does not work.
• "Position Error Push Open Key" appears on
the monitor.
• "Mecha Error Push Reset" appears on the
monitor, and the panel does not move.
• "SD Loading Error" appears on the monitor.
Remedies/Causes
• Center speaker is not activated. ( page 57)
• Center speaker is used only for surround playback. No
sound comes out for stereo playback.
• Rear speakers and subwoofer are not activated. (
page 57)
• When Dual Zone is in use, this is normal with <Off>
selected for <Rear Speaker>. ( page 61)
This happens while playing some discs with <Auto>
selected for <Surround Mode> ( page 24).
Cancel surround.
Sunshine from the windscreen may cause this symptom.
Adjust <Bright>. ( page 54)
Deactivate Dual Zone. ( page 27)
(While Dual Zone is activated, you cannot select them as
the source.)
Deactivate Dual Zone. ( page 27)
(While Dual Zone is activated, the remote controller only
functions for operating the DVD/CD player.)
The monitor panel angle has been forcibly adjusted, or its
adjustment has been interrupted while opening or closing.
Press OPEN/TILT (CLOSE).
Reset the unit ( page 3).
SD is not inserted fully. Fully insert it into the slot to close
the monitor panel.
72