General International DP2002 Mode D'emploi page 8

19. NEVER TURN THE MACHINE ON
before clearing the table/work area of all objects (tools, scraps of
wood, etc.). Flying debris is dangerous.
20. DISCONNNECT THE PLUG FROM POWER BEFORE MAKING ANY
ADJUSTMENTS.
Changing attachments, making bit changes, adjustments or repairs or
accessories can be dangerous if the tool could accidentally start. Turn
off and unplug the drill press before moving it.
21. TURN THE MACHINE OFF,
disconnect the machine from the power source, when not in operation
and before leaving the machine. Clean the table/work area before
leaving the machine.
22. DO NOT LEAVE THE WORK AREA UNTIL ALL MOVING PARTS
HAVE STOPPED.
Shut off the power to master switches. Childproof the workshop!
23. TO FREE ANY JAMMED MATERIAL, TURN THE SWITCH OFF.
Unplug the tool. Wait for all moving parts to stop before removing the
jammed material.
24. NEVER WORK FREE HAND
(hand-holding the workpiece rather than supporting it on the table),
except when polishing.
25. PREVENT THE WORKPIECE FROM BEING PULLED OUT OF
YOUR HANDS, SPINNING ON THE TABLE,
shattering the tool, or being thrown. Always support your work so it
won't shift or bind on the tool.
26. ALWAYS POSITION THE WORKPIECE AND BACKUP MATERIAL
(used beneath the workpiece) to contact the left side of the column.
Whenever possible, position the workpiece to contact the left side of
the column — if it is short or the table is tilted, clamp it solidly to the
table.
27. CLAMP OR BRACE WORKPIECE AGAINST COLUMN
to prevent rotation.
28. SUPPORT THE WORKPIECE FIRMLY WITH A CLAMP,
vise, or work table when drilling. Hold the workpiece firmly. Loss of
control of the workpiece can result in injury.
29. WHEN USING A DRILL PRESS VISE,
always fasten it securely to the table.
30. PROPERLY SUPPORT LONG OR WIDE WORKPIECES.
If a workpiece overhangs the table so that it could fall or tip if not held,
clamp it to the table or provide auxiliary support(s). Loss of control of
the workpiece is dangerous.
31. SUPPORT ROUND WORK PROPERLY
Use V blocks to prevent it from rolling.
32. USE THE RECOMMENDED SPINDLE SPEED
for the specific operation and workpiece material — check the label
inside the pulley cover for drilling information
33. KEEP PULLEY COVER CLOSED
when not making belt adjustments.
34. TO AVOID INJURY FROM THROWN WORK OR TOOL CONTACT,
do not perform layout, assembly, or setup work on the table while the
chuck is rotating.
35. USE ONLY ACCESSORIES DESIGNED FOR THIS DRILL PRESS
to avoid serious injury from thrown, broken parts or work pieces.
36. WHEN CUTTING LARGE DIAMETER HOLES, CLAMP THE
WORKPIECE FIRMLY TO THE TABLE.
Otherwise the cutter may grab and spin at high speed. Use only one
piece, cup-type hole cutters. DO NOT use fly cutters or multi-part hole
cutters as they may come apart or become unbalanced in use.
8