General International DP2002 Mode D'emploi page 14

5. Install an M5 x 12 pan head screw from the inside of the pulley cover
through the hole and attach the knob (aa, fig 3) to the outside.
NOTE: One or two of the feed handles may have to be temporarily
removed in future if a job involves an unusually-shaped workpiece that
interferes with handle rotation.
CHUCK
1. Clean out the tapered hole in the chuck (K, fig 2 & 3), removing any
grease, anti-rust coating or dirt you find.
2. Clean grease, coating and dirt from the JT33 tapered spindle tip with a
clean cloth.
3. Open the chuck's jaws as far as they will go so they are fully retracted
into the chuck.
4. Push the chuck up on the spindle as far as possible. Lightly tap the
lower end of the chuck with a piece of wood to ensure the chuck fits
tightly on the spindle.
5. To remove the chuck, see Maintenance.
LASER BATTERIES
1. Locate the laser switch (T, fig 3) on the left side of the head assembly.
2. Press the tab located below the laser switch (fig 6) and raise the cover.
3. Insert 2 "AA" batteries, oriented in the directions indicated.
4. Close the switch cover.
CAUTION: Remove these batteries from the compartment when the
tool is to be stored without use for more than a few days. If left in, the
batteries may leak and damage the laser device. Damage from leaking
batteries is not covered under the warranty.
ADJUSTMENTS
WARNING! To reduce the risk of injury, keep pulley cover in place and
in proper working order when operating.
SPEED AND BELT TENSION
ADJUSTMENT
1. Open the belt & pulley cover (X, fig 2 & 3)
2. Consult the belt position / speed diagram.
rpm: 570 tr/min
spindle
broche
rpm: 1390 tr/min
spindle motor
broche moteur
3. Loosen the belt tension lock knobs; one on each side of the drill press
head.
4. Pull the motor forward, closer to the drill press head.
5. Choose the best speed for the drilling operation planned and install the
belt in the correct position on the pulleys to produce that speed.
14
DP2002 belt spindle label
100 x 40 mm R=2
rpm: 900 tr/min
motor spindle motor
moteur broche moteur
rpm: 2050 tr/min rpm: 3050 tr/min
spindle motor spindle
broche moteur broche
g 6
motor
moteur
T
!
!