Installation; Electrical Connection; Positioning And Levelling - Whirlpool AXMT 6534/IX Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation

Positioning and levelling

The appliance may be installed alongside any
cupboards whose height does not exceed that of the
hob surface.
Make sure that the wall which is in contact with the
back of the appliance is made from a non-flammable,
heat-resistant material (T 90°C).
To install the appliance correctly:
• Place it in the kitchen, the dining room or the studio
flat (not in the bathroom).
• If the top of the hob is higher than the cupboards,
the appliance must be installed at least 600
from them.
• If the cooker is installed underneath a wall cabinet,
there must be a minimum distance of 420 mm
between this cabinet and the top of the hob.
HOOD
600
Min.
mm.
with the instructions listed in the relevant operating
manual.
Levelling
If it is necessary to level the
appliance, screw the
adjustable feet into the
positions provided on each
corner of the base of the
cooker ( see figure ).
The legs* fit into the slots on the
underside of the base of the
cooker.
appliance, screw the adjustable
The appliance must not be installed behind
a decorative door in order to avoid overheating
This distance should be
increased to 700 mm
if the wall cabinets are
flammable (see fi gure).
Do not position
or less than 200 mm
mm away
away from its sides.
Any hoods must be
installed in accordance

Electrical connection

Fitting the power supply cable
To open the terminal board:
• Insert a screwdriver into the side tabs of the terminal
board cover.
• Pull the cover to open it.
• Loosen the cable clamp screw and the wire contact
screws.
The jumpers are pre-set at the Factory for 230 V
single-phase connection (see fi gure).
230V ~
H05RR-F 3x4 CEI-UNEL 35363
H05VV-F 3x4 CEI-UNEL 35746
N
L
• To carry out the electrical connections as shown in
the figures, use the two jumpers inside the box (see
fi gure - labelled "P").
N
L1
400V 2N~
H05RR-F 4x4 CEI-UNEL 35363
H05VV-F 4x4 CEI-UNEL 35746
N
L2 L1
400V 3N~
H05RR-F 5x2.5 CEI-UNEL 35363
H05VV-F 5x2.5 CEI-UNEL 35746
N
To install the cable,
follow the instructions
below:
P
L2
L3
L3
L2
L1
GB
23

Publicité

Table des Matières
loading

Table des Matières