Installing The Modem Driver - Sony PCGA-BM1 Mode D'emploi

Installing the Modem Driver

Install the modem driver on the notebook which is to be used for
communication with the PCGA-BM1.
Note
Before starting the procedure below, the notebook must be set up to read CD-ROM discs.
For details on CD-ROM use, refer to the manuals provided with your Sony notebook and/
or the CD-ROM drive.
1
Turn on the power of the PCGA-BM1.
For details, see the section "Installation" in PCGA-BM1 Operating
Instructions.
2
Execute Bluetooth communications at the notebook to
connect to the PCGA-BM1.
Carry out steps 1 - 4 in the section "Notebook bonding" (page 19) in
the PCGA-BM1 Operating Instructions.
3
Check the communications port allocated to Bluetooth
communications.
For details on how to check the communications port, refer to the
manuals provided with your Sony notebook.
4
Click the "Start" button, move the pointer to "Settings", and
click "Control Panel".
5
Double-click the "Phone and Modem Options" icon to open
the "Phone and Modem Options" dialog box.
6
Select the "Modems" tab and click the "Add" button.
The "Install New Modem" dialog box appears.
7
Click the "Next" button.
8
Select the communications port checked in step 3, and click
the "Next" button.
Detection of a new modem is carried out and the result is shown on
screen.
Continued on next page
GB
9