Cabela's CXPRO 10x50 LRF Mode D'emploi page 4

4
I NS TR U CT I O NS F OR US E
STEP 1
Your CXPRO Laser Range nder Binoculars come with
1 CR2 3V lithium battery preinstalled.
NOTE: Remember to rst remove the battery cap and
take out the spacer from under the battery prior to
using illumination. The spacer prevents the battery
from activating during shipment.
To install or replace the battery, follow the steps below:
NOTE: When disposing of the battery, follow your local-
NOTE: Ensure the battery cap is secured in place
NOTE: Your CXPRO Laser Range nder will automatically
NOTE: Your battery life will depend on the mode you
You are now ready to start using your laser
range nder binoculars.
Installing or Replacing Your Battery
Step 1 – Place a at-head screwdriver, quarter,
or nickel in the battery cover slot.
Unscrew the battery cap in the
counterclockwise direction. Remove
the cap and used battery.
Step 2 – Next, place the battery in the
compartment so that the battery's
positive side is in the same direction
shown by the battery symbol on the
bottom of the binoculars.
Step 3 – Replace the battery cover back on the
battery housing by screwing on clock-
wise to tighten.
area regulations.
in order to preserve the laser range nder's
waterproof capability. Do not overtighten the
battery cap.
shut off after 20 seconds of nonuse.
are using and the outside temperature. Your
battery should last approximately 3,000
measurement readings. Colder environments
will cause the battery life to be shorter.
LOW BATTERY will illuminate when there is
approximately enough power for 250 more
readings. It is recommended that you replace
the battery after the wording illuminates.