Cabela's CXPRO 10x50 LRF Mode D'emploi page 12

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STEP 8
Menu Operation – Ri e Mode Continued
Step 4 – If you would also like to change the display bright-
ness and the unit of measurement (Yards or Meters),
continue to Step 4 and Step 5 below. Otherwise, you
can hold down the Mode button for 3 seconds to
exit out of the Mode Menu without making any
additional changes.
When in the Ri e Mode, press the Range button to
take a distance measurement. The Line Of Sight (LOS)
Value will rst display for 1 to 2 seconds at the top of
the display, and then will go off, immediately followed
by either the hold over in inches or elevation adjust-
ment value in MOA or MILIRADIANS (MIL) in
the bottom of the viewing screen.
The ri e symbol displayed at the bottom of the
screen indicates you are in the Ri e Mode.
Step 5 – The display brightness level will blink next.
Press the Range button to advance to each
level. There are a total of 5 display brightness
levels. Press the Mode button to select the
preferred level of brightness.
Step 6 – Next, the unit-of-measurement symbol will
start to blink. Press the Range button to cycle
between the 2 available units of measurement –
Meters (M) or Yards (Y). Once you see the
unit of measurement you would like to use,
press the Mode button down once to select
your preferred unit of measurement.
NOTE:
If using the SCAN feature
when in the Ri e Mode,
only the Line-of-Sight
(LOS) Distance will be
displayed (4 readings per
second). The hold over or
elevation adjustment value
will not be displayed while
in SCAN mode.
To learn how to focus your CXPRO Laser Range nding Binoculars,
see the next section, Step 9.
12
IN ST R U CT I O NS F O R U SE CO NT.
NOTE:
To exit the menu at at any
time, hold down the Mode
button for 3 seconds.
NOTE: The display will continue to ash,
alternating between the Line-of-Sight
Value and the hold-over (inches),
elevation adjustment value (MOA or MIL)
for a total of 10 seconds, or until you
take another measurement.
Line of Sight (LOS) blinks
at the top of the display.
Hold over in inches if
selected will blink at the
bottom as shown.
Elevation adjustment
units in MIL if selected
will blink at the bottom.
Elevation adjustment
units in MOA if selected
will blink at the bottom.

Publicité

Table des Matières
loading

Produits Connexes pour Cabela's CXPRO 10x50 LRF

Ce manuel est également adapté pour:

2512148

Table des Matières