Installation; Extension Cords - Heat Wagon 1800B Manuel D'installation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The Heat Wagon Model 1800B(L) is a direct fired gas heater intended to be used primarily for the
temporary heating of building under construction, alteration, or repair. Since all the products of
combustion are released into the area being heated, it is imperative that adequate ventilation is pro-
vided. The flow of supply air and combustion gases must not be obstructed in any way.
1. The heater is designed for indoor or outdoor installation in a horizontal position. Allow the
following clearances from any combustible material or fuel containers.
Front Outlet:
Intake:
Also make sure that no flammable vapors are present in the space where the heaters is being used.
2. The heater should be inspected before each use, and at least annually by a qualified service
person.
3. The hose assembly must be inspected prior to each use of the heater. If it is evident that there is
excessive abrasion or wear, or the hose is cut, it must be replaced prior to the heater being put into
operation. The replacement hose assembly shall be that specified by the manufacturer.
4. When connecting the heater to a natural gas or propane supply line ensure that the pressure at
the heater inlet is within the specified range. Excessive pressure over (14" W.C.) will damage the
controls and void the warranty.
5. Connect the hose assembly to the heater gas inlet elbow. The 1800B elbow has a 3/4" female
NPT thread, 1800BL elbow has a 1/4" female NPT thread. Use a minimum inside diameter of 1/2"
on LP or 3/4" on natural gas installations. Ensure that the hose assembly is protected from
traffic, building materials, and contact with hot surfaces.
6. After installation, check hose assembly for gas leaks by applying a soap and water solution to
each connection.
7. Connect the heater to an adequate 120 volt electrical supply as specified on the rating plate. For
protection against shock hazard the supply cord should be plugged directly into a properly ground-
ed three-prong receptacle.
8. Replacement parts are available from any Heat Wagon distributor or by calling 1-888-432-8924
for parts information.

INSTALLATION

20 feet
2 feet

EXTENSION CORDS:

Properly Wired and Grounded
Use #14 wire up to 100'
Use #12 wire up to 200'
Use #10 wire up to 300'
Sides:
2 feet
Top:
4 feet
5

Publicité

Chapitres

Table des Matières
loading

Produits Connexes pour Heat Wagon 1800B

Ce manuel est également adapté pour:

1800bl950h950hl

Table des Matières